In any case a reload is needed at the end to make the change effective. The command is given in configuration mode and you have to save the configuration. The second method is related to using Smart Licensing. The first method looks like to use a license file. The following page describes the available methods to install the booster performance license. You need to follow the normal installation procedure include reboot at the end. You can install boost license with CSL license. TAC already raised a bug to correct the documentation. > You don't need to register with smart license to install boost license. In that thread there is post from Cisco employee Sxnguyen reporting the following note: Which two pieces of information can be obtained from the partial output of the "Show ntp associations detail" command on R2? (Choose two.) 1.)The IP address of R1 is 192.168.1.2Ģ.Yes the thread I have mentioned reports an issue with documentation that has been probably fixed. One router is configured as the NTP master, and the other is a NTP client. Router 1 and Router 2 are connected via a serial link. Which ACE will meet this requirement? 5 deny 172.23.16.0 0.0.15.255 R2# show ntp associations detailġ92.168.1.2 configured, authenticated, our_master, sane, valid, A network administrator needs to add an ACE to the TRAFFIC-CONTROL ACL that will deny IP traffic from the subnet 172.23.16.0/20. What is the first available host address in the next available subnet? 10.10.249.1 Router1# show access-listsġ0 permit 172.23.0.0, wildcard bits 0.0.255.255 To optimize the use of this address space, the new subnet will follow on directly from the existing subnets. THe administrator has to create a third subnet from the remaining address range. Two devices on two different, but contiguous, subnets on the LAN have been assigned the addresses 10.10.247.1/21 and 10.10.248.10/24, respectively.
Which statement describes a disadvantage of using the Cisco TFTP service to. A network administrator has been allocated the IPv4 10.10.240.0/20 block of addresses for a LAN. Which statement about the Cisco UC on UCS TRC and the third-party server. What two things does the administrator need to know before preforming this task? (Choose two.) 1.)Name of the configuration file that is currently stored on the router.Ģ.)Name of the configuration file that is stored on the TFTP server. After a license has been purchased and installed, what is the next step that is required before it is activated? Reboot the Router An Administrator wants to replace the configuration file on a Cisco router by loading new configuration file from a TFTP server.
0 kommentar(er)
